Attaching And Aligning The Appliance; Attaching The Flue Duct - Gaggenau AW 2 Séries Notice D'utilisation Et De Montage

Attaching and aligning the appliance

1 First, remove the protective foil from the back of the
appliance and, following installation, remove the foil
completely.
2
3
¬
4
5
«
®
¯
Connecting the pipes
Note: . If using an aluminium pipe, smooth the connection area
beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe connector
and seal.
Exhaust-air pipe Ø 120 mm
1 Attach the reducing connector directly to the air-pipe
connector.
2 Attach the exhaust air pipe to the reducing connector.
3 Seal both joints appropriately.

Attaching the flue duct

m
Warning. Risk of injury!
Components inside the appliance may have sharp edges.
Wear protective gloves.
1 Separate the flue ducts.
To do this, remove the adhesive tape.
2 Remove the protective foil from both flue ducts.
3 Push one flue duct into the other.
Notes
–
To prevent scratches, lay paper over the edges of the
lower flue duct to protect the surface.
–
Slots of the inner flue duct point downwards.
4 Place flue ducts on the appliance.
5
6
7
ª
Installation
en
¨
©