Sensor Control; Saturation Display; Button Tone - Gaggenau AC250121 Notice D'utilisation

Sensor control

In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting
odours. Depending on the sensor setting, the fan
automatically switches itself to another fan setting.
Possible sensor settings:
Default sensitivity setting: LED 3 (fan setting 3)
Lowest sensitivity setting: LED 1 (fan setting 1)
Highest sensitivity setting: LED 5 (intensive mode 2)
If the sensor control responds too strongly or not
enough, it can be changed accordingly:
1 With the appliance switched off, press and hold the
# and r buttons for approximately 3 seconds.
Press the @ or A button to change the sensor
2
control setting.
Press and hold the # and r buttons for
3
approximately 3 seconds to save the setting or wait
for around 10 seconds until the setting is saved
automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.

Saturation display

If the metal grease filters or the air recirculation filter is/
are saturated, the corresponding symbols will flash and
a repeated signal tone will sound after the appliance
has been switched off:
▯
Metal grease filter: LED 1 flashes
▯
Air recirculation filter: LED 2 flashes
▯
Metal grease filter and air recirculation filter:
LEDs 1 and 2 flash
Clean the metal grease filters or replace the air
recirculation filter now if you have not already done so.
"Cleaning and maintenance" on page 39
~
While they are flashing, the saturation indicators can be
reset by pressing the œ button.
Switching to air recirculation mode
For air recirculation mode, the electronic controller
must be switched over accordingly.
1 With the appliance switched off, press and hold the
# and œ buttons for approximately 3 seconds.
The LED for the currently active filter setting lights
up on the appliance.
Press the @ button/A button until LED 2 for air
2
recirculation mode (filter cannot be regenerated)
lights up on the appliance.
Press the @ button/ A button until LED 3 for air
3
recirculation mode (filter can be regenerated) lights
up on the appliance.
Press the @ button/A button until LED 1 on the
4
appliance for the electronic controller is switched
back to operation without the air recirculation filter.
Press and hold the # and œ buttons for
5
approximately 3 seconds to save the setting or wait
for around 10 seconds until the setting is saved
automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.

Button tone

Switching on or off
Note: Only button tones can be switched on and off.
Signal tones on the appliance cannot be switched off.
1 When the appliance is switched off, press and hold
the # and A buttons for approx. 3 seconds.
The LED in the currently selected setting lights up.
Press the @ or A button to change the setting.
2
The button tones are switched on if LED 1 lights up
on the appliance.
The button tones are switched off if LED 2 lights up
on the appliance.
Press and hold the # and A buttons for approx.
3
3 seconds to save the setting or wait for approx.
10 seconds until the setting is automatically saved.
A signal tone will sound.
Note: Press the # button to cancel the setting.
Operating the appliance
en
35