Installation Safety Check - Harmony DEFENDER 360 Manuel D'instructions

Your vehicle's
Anchor Points may be identified
using one of these symbols:
• Check that the Top Tether is securely attached to the
child restraint.
• Fasten Top Tether clip to anchor point ensuring the clip
is facing downwards and the strap is not twisted ❶.
• With the child restraint installed with the UAS or
vehicle seat belt, tighten the Top Tether strap securely
by pulling on the free end of the Top Tether strap ❷.
• To loosen, press the Top Tether release button ❸.
❶
! WARNING: Ensure that Top Tether strap is NOT
twisted.

INSTALLATION SAFETY CHECK

Perform this test EVERY TIME you
drive with your child and whenever
you readjust the child restraint as
your child grows:
Rock the child restraint back and
forth and side to side to make sure
the UAS or vehicle seat belt does
not lengthen or loosen, and the child restraint does not
move easily ❶.
The back of the child restraint (connection point) should
not move more than 2.5 cm (1 inch) in any direction.
31
Top Tether
❷
❸
❶