Installing/Removing Shoulder Belt Guide; Using Shoulder Belt Guide - Harmony DEFENDER 360 Manuel D'instructions

! WARNING: To avoid possible entanglement hazard,
see "Entanglement with vehicle seat belt".
! THE VEHICLE'S SHOULDER BELT MUST LIE ACROSS THE
CHILD'S SHOULDER AND LAY ACROSS THE CHEST –
NOT THE FACE OR NECK. If the belt does not lie properly
across the child's shoulder and chest, the RED shoulder
belt guide ("Parts list - V") MUST be used to ensure
proper placement (see "Using shoulder belt guide").

INSTALLING/REMOVING SHOULDER BELT GUIDE

TO INSTALL
1. Locate the shoulder belt guide
strap and screw ("Parts list - V") in
the storage pouch.
2. Using a
attach belt guide strap to booster
seat base by screwing into the
pre-drilled hole in the back of the
seat base.
! Before tightening screw, make sure belt strap is
pointing upwards and that the RED belt guide opening
is facing forward. DO NOT overtighten screw.
TO REMOVE
1. Remove vehicle seat belt from RED belt guide clip.
2. Unscrew shoulder belt guide from the back of the
base.
It is recommended to store the unused shoulder belt
guide along with any other parts from the child restraint
for future use.

USING SHOULDER BELT GUIDE

1. Slide the vehicle's shoulder belt into the RED clip
ensuring it is flat. Position the belt guide just above
the child's shoulder ❶.
43
Phillips screwdriver,
Pilot
hole
Base
plate