than those described in the instructions and marked in
the child restraint.
IF IN DOUBT ABOUT THESE POINTS OR ANY
QUESTIONS RELATED TO INSTALLATION, PLEASE
CONTACT HARMONY JUVENILE PRODUCTS.
INSTALLATION - BOOSTER WITH BACKREST
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child in the booster seat with child's back flat
against the back of the booster seat.
3. Adjust headrest height so that the bottom of the
❺
WARNING!
!
❻
❼
40