Installation - Booster With Backrest - Harmony DREAMTIME DELUXE Manuel D'instructions

INSTALLATION - BOOSTER WITH BACKREST

DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child in the booster seat with
child's back flat against the back of
the booster seat.
3. Adjust
height so that the
bottom of the
headrest is EVEN
with the top of
the child's shoulders. See section
"Headrest height adjustment".
4. Thread shoulder belt portion of the 3-point lap-and-
shoulder belt system through the shoulder belt guide
❶ and ensure that shoulder belt lies across child's
shoulder and chest, and NOT across child's face or neck.
5. Thread both sides of the lap belt under BOTH
armrests. Thread the lower end of the shoulder
belt under the armrest on the buckle side ❷.
ENSURE that the belt is snug across the child's hips.
It is important to ensure that any lap strap is worn
21
WARNING!
!
headrest
❶
❷