USING CUP HOLDER (WHEN APPLICABLE)
TO INSTALL:
1. Remove protective cap from the
desired side by lifting release tab on
protective cap and pulling cap off ❶.
Store protective cap for future use.
2. Slide cup holder into place over cup
holder clip ❷ until locked in place.
TO REMOVE:
1. Lift release tab on cup holder and pull
cup holder off cup holder clip. Replace
protective cap if desired.
When not in use, the cup holder can be
stored in the cavity on the underside of
the booster seat base.
• To remove from storage, pull the cup
holder.
This booster seat is NOT CERTIFIED for aircraft use. Aircraft
seats are not equipped with 3-point lap-and-shoulder
belts which are required for use with this booster seat.
INSTRUCTION MANUAL STORAGE
We recommend that you store your
instruction manual in the pocket provided
on the side of the booster seat.
When using the seat as a backless booster,
we recommend that you store your
instruction manual under the fabric cover
on the side of the booster seat.
25
AIRCRAFT INSTALLATION
❶
❷