Installing Cup Holder (When Applicable); Aircraft Installation; Instruction Manual Storage - Harmony DEFENDER 360 Manuel D'instructions

INSTALLING CUP HOLDER (WHEN APPLICABLE)

1. The cup holder can be installed on
either side of the child restraint.
2. Locate the opening in the end of
either armrest.
3. Insert cup holder clip into the
opening and push in until locked
into place. Ensure that the fabric
does not interfere with the
installation. If so, gently pull down on the fabric while
installing cup holder.
4. Pull out to remove.
This child restraint is certified for use in aircraft ONLY
when used WITH the harness.
This child restraint is NOT CERTIFIED for aircraft use
when used as a booster WITHOUT the harness.
IMPORTANT POINTS TO REMEMBER:
1. Contact your airline before using this child restraint
on the aircraft in order to comply with their
restrictions and regulations.
2. Install this child restraint on an aircraft in the same
way it is installed in an automobile with a lap belt.
3. Check that the aircraft seat belt holds the child
restraint securely in place at all times. If it does not,
DO NOT use this child restraint.

INSTRUCTION MANUAL STORAGE

Store your instruction manual in the
storage section provided in the base
plate on the bottom of your child
restraint.
45

AIRCRAFT INSTALLATION