Using Child Restraint With Built-In Harness - Harmony DEFENDER 360 Manuel D'instructions

Test installation to see if child restraint is secure. The
child restraint should NOT be able to move in any
direction where it connects to the vehicle. If the child
restraint can be moved more than 2.5 cm (1 inch) in
any direction at the connection point, then unbuckle
the seat completely and repeat the steps above until
secure (see "Installation safety check"). If you have any
questions, please contact Harmony Juvenile Products
customer service.
!
Store locking clip when not in use.
! DO NOT use locking clip in booster mode.
FAILURE TO FASTEN AND TIGHTEN THE HARNESS
SYSTEM CORRECTLY MAY CAUSE THE CHILD TO BE
EJECTED FROM THE RESTRAINT SYSTEM IN CASE
OF A SHARP TURN, SUDDEN STOP OR CRASH
CAUSING SERIOUS INJURY OR DEATH. In a crash,
the child restraint will provide NO protection for your
child unless the harness straps are properly secured.
DO NOT mistake comfort for safety. Harness system
MUST be snugly adjusted. Follow these instructions
carefully.
! Incorrect use of the harness system is the most
common mistake people make. It is VERY important
to read, understand and follow ALL instructions and
warnings. DO NOT mistake comfort for safety. The
harness system MUST be snugly adjusted at all times.
!
Snugly adjust the harness provided with this child
restraint around your child. A snug strap is one with no
slack. It should not press on the child's flesh or cause
your child's body to be in an unnatural position. You
should only be able to slide ONE FINGER between the
shoulder straps and the child's shoulder.
33
USING CHILD RESTRAINT
WITH BUILT-IN HARNESS
WARNING!
!