5. Should you need to loosen the UAS,
push the UAS release button ❺.
!
WARNING: NEVER put two UAS
connectors on one vehicle UAS
anchor unless specifically allowed
by the manufacturer ❻.
6. Secure the top of the child
restraint using the top tether
strap (see "Using top tether").
!
Conduct a safety check for a secure
installation (see "Installation safety
check"). Perform this test every
time you drive with your child and
whenever you readjust the child
restraint as your child grows.
INSTALLING WITH LAP-AND-SHOULDER
If a UAS installation is not an option,
then use the following belt-only
installation method.
!
WARNING: UAS must be stored
when using the vehicle belt. Clip
both UAS hooks to the fabric loops
on each side of the backrest ❶.
1. Place the child restraint flush
against the back of a forward-
facing
the recline as necessary (see
"Recline").
2. Thread the vehicle seat belt
through the belt slot opening and
out the other side. See illustrations
for proper routing path of Lap-and-Shoulder Belt ❷
or Lap-Only Belt ❸.
29
OR LAP-ONLY BELT SYSTEM
vehicle
seat.
❻
Adjust
❺
❶
❷