Assembling/Disassembling Child Restraint - Harmony DEFENDER 360 Manuel D'instructions

ASSEMBLING/DISASSEMBLING CHILD RESTRAINT

Adult assembly: 2 x Phillips Screwdrivers required.
1. Locate both sets of screws with plastic knob, washers
and plastic encased inner bolts ("Parts list - T") in the
hardware bag and set aside.
2. Locate the 1.3 cm (0.5 inch) connector rod screw and
washer ("Parts list - X") in the hardware bag and set aside.
3. Identify the 22.3 cm (8.8 inch) backrest connector
rod ("Parts list - W") pre-installed in base of backrest.
Remove and set aside.
4. Place the backrest and base face down and slide
the base plate between the two backrest anchor
points. Pass the
22.3 cm (8.8
inch) connector
rod through
assembly. Insert
the
and 1.3 cm (0.5
inch) screw on
opposite
and tighten ❶.
TIP: If connector rod does not pass through easily, make
sure it is aligned with holes and tap screw head
lightly to guide it through the plastic.
5. Turn assembly face-up and pull the backrest
up into the vertical position. Pull up-front
adjuster tight to hold the backrest in place.
Connect the backrest to the base
in the upright position, ensuring
that the backrest inserts snugly
around the outside of the armrest
grooves. Insert screw, washers (x2)
and inner bolt as indicated in each
armrest ❷. Ensure that the bolt is properly aligned
with the indentation ❸ . Secure assembly by turning
screw clockwise until tight ❹.
washer
Connector
side
Part 'X'
(screw &
washer)
rod
Backrest
anchor points
Base
plate
❶
❷
22