Electrical Connection; Important; Commissioning - JAC GD Mode D'emploi

5.3

Electrical connection:

IMPORTANT: This machine must be earthed.
It is recommended that the system be protected with a fuse and an RCD.
Your mains electricity supply to the machine must be protected as indicated below:
- North America: 15 A protection;
- Rest of the world: 16 A protection.
For machines equipped with a variable speed drive, it is imperative that they be connected to a
junction box on a circuit fitted with a 300 mA RCD.
Note: Any problem resulting from any other type of connection will not be covered under warranty.
Before connecting your machine to the mains supply and in order to prevent the motor from burning
out when it is switched on, it is important to check that the mains supply matches the machine
specification (see machine nameplate).
This machine complies with Machinery Directives 2006/42, 2006/95, 2004/108 and is CE marked as
proof of this.
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find it at the back of the machine close
to the power cable and inside the machine on the electrical enclosure (fig.7, n°25).
You will find the circuit diagram for the machine on the back of the electrical
enclosure door (fig.7, n°26).
5.4

Commissioning:

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
Check that the oil indicator light on the control panel is not lit. If it is, add 5 litres of oil via the oil
filler plug (the machine will not operate if the oil level is down to the minimum).
The machine is equipped with a variable speed drive, therefore the direction of rotation of
the various operating components need not be checked. The machine is ready for use
when connected.
For machine operation, refer to the "Operation" chapter.
English
10