Before Operation; Before Operation Safety - Toro TimeCutter ZS 4200T Manuel De L'utilisateur

Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
(Figure 27).
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

•
Evaluate the terrain to determine what accessories
and attachments are needed to properly and
safely perform the job. Only use accessories and
attachments approved by Toro.
•
Inspect the area where the equipment is to be
used and remove all rocks, toys, sticks, wires,
bones, and other foreign objects. These can
be thrown or interfere with the operation of the
machine and may cause personal injury to the
operator or bystanders.
•
Wear appropriate personal protective equipment
such as safety glasses, substantial slip-resistant
footwear, and hearing protection. Tie back long
hair and avoid loose clothing and loose jewelry
which may get tangled in moving parts.
CAUTION
This machine produces sound levels in
excess of 85 dBA at the operator's ear and
can cause hearing loss through extended
periods of exposure.
Wear hearing protection when operating
this machine.
•
Check that the operator presence controls,
safety switches, and shields are attached and
functioning properly. Do Not operate unless they
are functioning properly.
•
Do Not operate the mower when people, especially
children, or pets are in the area. Stop the machine
and attachment(s) if anyone enters the area.
•
Do Not operate the machine without the entire
grass collection system, discharge deflector,
or other safety devices in place and in proper
working condition. Grass catcher components
are subject to wear, damage and deterioration,
which could expose moving parts or allow objects
to be thrown. Frequently check for worn or
deteriorating components and replace them with
the manufacturer's recommended parts when
necessary.
11