Servicing The Fuses; Drive System Maintenance; Checking The Tire Pressure - Toro TimeCutter ZS 4200T Manuel De L'utilisateur

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse type:
•
Main—F1 (25 A, blade-type)
•
Charge Circuit—F2 (15 A, blade-type)
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the seat to access the fuses.
4. To replace a fuse, pull out the fuse to remove
it (Figure 49).
Figure 49
1. Charge circuit (15 A)
5. Lower the seat.
ARK
g293931
2. Main (25 A)
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause an uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive-wheel tires to 90 kPa (13 psi).
1. Valve stem
39
(Figure
Figure 50
50).
g000554