Removing The Mower Deck - Toro TimeCutter ZS 4200T Manuel De L'utilisateur

Adjusting the Front-to-Rear Blade
Slope
1. Rotate the adjustment nut in the front of the
mower (Figure 68).
Figure 68
1. Adjusting rod
2. Adjusting block
2. To raise the front of the mower, tighten the
adjustment nut.
3. To lower the front of the mower, loosen the
adjustment nut.
4. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
5. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to Checking the Side-to-Side Level (page
44).
g294471
3. Adjustment nut
(Figure 63).

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Loosen the bottom 2 bolts holding the
mower-deck curtain to the mower deck. Refer to
Releasing the Mower-Deck Curtain (page
5. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure 69).
1. Front support rod
2. Locking nut
6. Carefully lower the front of the mower deck to
the ground.
7. On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin
47
ARK
Figure 69
3. Deck bracket
(Figure
30).
g014635
70).