Removing The Mower Deck; Installing The Mower Deck - Toro TimeCutter ZS 4200S Manuel De L'utilisateur

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Loosen the bottom 2 bolts holding the
mower-deck curtain to the mower deck. Refer to
Releasing the Mower-Deck Curtain (page
5. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure 70).
Figure 70
1. Front support rod
2. Locking nut
6. Carefully lower the front of the mower deck to
the ground.
7. On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin
ARK
29).
g014635
3. Deck bracket
(Figure 71).
1. Lift arm
2. Hairpin cotter
8. Remove the lift arm from the deck pin
71).
9. Repeat steps
machine.
10. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
11. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.

Installing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. On 1 side of the machine, lift the rear of the
mower deck and install the lift arm to the deck
pin (Figure 71).
6. Install the lift arm using the washer and hairpin
cotter (Figure
7. Repeat steps
machine.
46
Figure 71
3. Washer
7 and 8 for the other side of the
71).
5 and 6 for the other side of the
g295768
(Figure
ARK