After Operation; After Operation Safety; Pushing The Machine By Hand - Toro TimeCutter ZS 4200S Manuel De L'utilisateur

drop onto your lawn. To avoid this, move onto a
previously cut area with the blades engaged or you
can disengage the mower deck while moving forward.
Keeping the Underside of the
Mower Deck Clean
Clean clippings and dirt from the underside of the
mower deck after each use. If grass and dirt build up
inside the mower deck, cutting quality will eventually
become unsatisfactory.
Maintaining the Blade(s)
Maintain a sharp blade throughout the cutting season
because a sharp blade cuts cleanly without tearing or
shredding the grass blades. Tearing and shredding
turns grass brown at the edges, which slows growth
and increases the chance of disease. Check the
mower blades after each use for sharpness, and
for any wear or damage. File down any nicks and
sharpen the blades as necessary. If a blade is
damaged or worn, replace it immediately with a
genuine Toro replacement blade.

After Operation

After Operation Safety

General Safety
•
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's position. Allow the machine to cool
before servicing, adjusting, fueling, cleaning, or
storing it.
•
Clean grass and debris from the cutting unit,
muffler, drives, grass catcher, and engine
compartment to help prevent fires. Clean up oil or
fuel spills.
•
Shut off the fuel and remove the key before storing
or transporting the machine.
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Do not tow the machine, because towing may
damage it.
This machine has an electric-brake mechanism,
and to push the machine, the key must be in the
position. The battery needs to be charged and
RUN
functioning to disengage the electric brake.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the
slotted hole and down to lock them in place
(Figure 30).
Note:
Do this for each lever.
WARNING
Contact with hot surfaces may cause
personal injury.
Keep your hands, feet, face, clothing
and other body parts away the engine,
muffler and other hot surfaces.
24
ARK