After Operation; Charging The Battery Pack - Toro Recycler 60 V MAX Manuel De L'utilisateur

After Operation

Charging the Battery Pack

Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 18
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
button
2. Line up the cavity in the battery pack
with the tongue on the charger.
3. Slide the battery pack into the charger until it is
fully seated (Figure
4. To remove the battery pack, slide the battery
backward out of the charger.
13).
5. LED indicators (current
charge)
7. Charger LED indicator
light
8. Charger venting areas
(Figure
18).
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator Indicates
light
No battery pack inserted
Off
Green Battery pack is charging
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
*Refer to Troubleshooting (page 26)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
g290533
18)
20
for more
25).