After Operation; After Operating Safety; Folding The Handle - Toro 20838 Manuel De L'utilisateur

After Operation

After Operating Safety

General Safety
•
Clean grass and debris from the machine to help prevent
fires. Clean up oil or fuel spills.
•
Allow the engine to cool before storing the machine in
any enclosure.
•
Never store the machine or fuel container where there is
an open flame, spark, or pilot light, such as on a water
heater or on other appliances.
Hauling Safety
•
Remove the electric-start button before loading the unit
for hauling.
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Use full-width ramps for loading the machine into a
trailer or truck. Do not exceed a 15° angle between the
ramp and the trailer or truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine.

Folding the Handle

WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the electric-start button (Figure 23).
14
Figure 23
1. Electric starter
2. Loosen the handle knobs.
3. Rotate the entire handle forward
Important: Route the cables to the outside of the
handle knobs as you fold the upper handle.
Figure 24
4. Rotate the upper portion of the handle back toward the
engine; refer to Figure
Figure 25
1. Handle knobs
5. To unfold the handle, refer to
(page 5).
2. Electric-start button
(Figure 24).
25.
1 Unfolding the Handle
g186627
g038688
g038687