Using The Self-Propel Drive; Shutting Off The Engine; Recycling The Clippings; Bagging The Clippings - Toro 20838 Manuel De L'utilisateur

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine automatically keeps pace with you
Figure 19

Shutting Off the Engine

Service Interval: Before each use or daily—Ensure that
the engine stops within 3 seconds after
releasing the blade-control bar.
Release the blade-control bar
Note: Remove the electric-start button whenever you leave
the machine.
Important: When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
Figure 20

Recycling the Clippings

Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
Note: The grass bag may remain on the machine while you
are recycling the clippings.
To recycle the clippings, move the bag-on-demand lever to
the recycling mode (Figure
(Figure 19).
(Figure 20).
21).
g003221
1. Recycling mode

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.

Installing the Grass Bag

1. Shut off the engine and wait for all moving parts to
stop.
2. Raise and hold up the rear door, install the bag in the
notches, and lower the rear door
3. Move the bag-on-demand lever to the bagging mode as
shown in Figure
g003126
12
Figure 21
2. Bagging mode
(Figure 22).
21.
g038696