Operating The Machine; Transporting The Machine - Toro TimeCutter ZS 4200S Manuel De L'utilisateur

5. Turn the ignition key on and disengage the
parking brake by moving 1 motion-control lever
out of the P position.
ARK
Note:
Do not start the machine.
Figure 30
1. Bypass-lever locations
2. Lever position for

operating the machine

6. When finished, ensure that the key has been
returned to the
STOP
the battery charge.
7. Move the motion-control levers outward to the
P position.
ARK
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
Do this for each lever.
3. Lever position for pushing
the machine
position to avoid draining
Figure

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
g295542
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure that the length of the ramp is at
30.
least 4 times as long as the height of the
trailer or truck bed to the ground. This
ensures that the ramp angle does not
exceed 15 degrees on flat ground.
25
(Figure 31).