Cleaning The Underside Of The Machine Housing - Toro Recycler 20995 Manuel De L'opérateur

Figure 52
4. Remove the blade, saving all mounting hardware
(Figure 52).
5. Install the new blade and all mounting hardware
(Figure 53).
Figure 53
Important: Position the curved ends of the blade
to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt to 82
N-m (60 ft-lb).
Important: A bolt torqued to 82 N-m (60 ft-lb) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
Cleaning the Underside of the
Machine Housing
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
machine housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle).
• Do not allow bystanders in the area.
1. With the engine running on a flat paved surface, spray
a stream of water in front of the right rear wheel
(Figure 54).
Note: The water will splash into the path of the blade,
cleaning out the clippings.
2. When no more clippings come out, stop the water and
move the machine to a dry area.
3. Run the engine for a few minutes to dry the housing
to prevent it from rusting.
20
Figure 54