Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro Recycler 20995 Manuel De L'opérateur

Model 20995 shown
2. Tighten all handle knobs.
3. Move the upper handle to the desired position and
tighten the upper handle knob firmly (model 20996
only) (Figure 5).
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: You must install the recoil-starter rope in
the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 6).
Figure 4
Figure 5
1. Recoil-starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Important: This machine does not come with oil in the
engine. Before starting the engine, fill the engine with
oil.
Important: Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer to
Changing the Engine Oil (page 17).
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 7) and pour about 3/4 of
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 0.59 l (20 oz.), type: SAE 30 detergent
oil with an API service classification of SF, SG, SH,
SJ, SL, or higher.
6
Figure 6
2. Rope guide