Installing The Fuse; Charging The Battery; Product Overview - Toro Recycler Manuel De L'utilisateur

3. Installing the Fuse

Procedure
Model 20638 only
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you
install the fuse.
1. Remove the battery cover and the battery and locate
the fuse holder (Figure 7).
1. Screw
2. Battery cover
2. Insert the fuse (from the loose parts bag) into the
fuse holder (Figure 8).
Note: Your mower comes with a fuse in the owner's
packet and another fuse in the battery box.
3. Install the battery and the battery cover.
Figure 7
3. Fuse holder
4. Battery
Figure 8

4. Charging the Battery

Procedure
Model 20638 only
Refer to Charging the Battery in the Maintenance
section.

Product Overview

Model 20638 shown
1. Lower handle lock
2. Grass bag
3. Upper handle lock
4. Recoil start handle
5. Upper handle (Models
20637 and 20638 only)
6. Blade control bar
7. Electric start (model 20638
only)
8. Rear door
6
Figure 9
9. Oil fill/Dipstick (not shown)
10. Fuel tank cap
11. Cutting height lever (2)
12. Spark plug
13. Primer
14. Air filter
15. Recycling/bagging lever