Charging The Battery (Electric-Start Model Only); Replacing The Fuse (Electric-Start Model Only) - Toro 29730 Manuel De L'utilisateur

g032026
Figure 27
•
If the oil level is below the Add mark on the
dipstick, add a small amount of oil slowly to the
oil-fill tube, and then repeat steps
until the oil level is at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick.
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
13. Install the dipstick securely by hand.
14. Recycle the used oil properly.
Charging the Battery
(Electric-start model only)
Service Interval: Every 25 hours
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Charge the battery for 24 hours initially, then monthly (every
25 starts) or as needed. Always use the charger in a sheltered
area and charge the battery at room temperature (70° or 22°
C) whenever possible.
1. Connect the charger to the wire harness located below
the ignition key (Figure
10 through
28).
2. Plug the charger into a wall outlet.
Note: When the battery no longer holds a charge,
recycle or dispose of the lead-acid battery according
to local codes.
Note: Your battery charger may have a 2-color LED display
that indicates the following states of charging:
•
A red light indicates that the charger is charging the
battery.
•
A green light indicates that the charger is fully charged or
the charger is disconnected from the battery.
12
•
A flashing light that alternates between red and green
indicates that the battery is nearly fully charged. This state
lasts only a few minutes until the battery is fully charged.
Replacing the Fuse
(Electric-start model only)
Your machine comes with a fuse that protects the electric
starter. If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown. Replace
it with a 40-amp plug-in type fuse.
Important: You cannot start the machine with the
electric starter or charge the battery unless you install
the fuse.
1. Unclip the battery cover and remove it
1. Battery cover
2. Foam
2. Insert the fuse into the fuse holder
16
Figure 28
(Figure
Figure 29
3. Battery
4. Fuse holder
(Figure 30).
29).