Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
IMPORTANT: Do not insert the key into the
plug receptacle until mower is fully
assembled.
Install Handle
IMPORTANT: Control cable must be over,
not under, handles (Fig. 2).
POTENTIAL HAZARD
Excessive pulling on control cable may
cause mower to start. When mower is
operating, blade is rotating.
WHAT CAN HAPPEN
Contact with rotating mower blade could
cause serious personal injury.
HOW TO AVOID THE HAZARD
Do not lift mower by control cable or pull
excessively on cable.
1.
Lift control cable above holes in rear of shroud.
2.
Lower Handle – Slide ends of lower handle into
holes in shroud.
If handle stops before screw holes are aligned in
center of shroud openings, push down on lower
handle section while pushing tubes into holes in
shroud (Fig. 3). Push tubes in until screw holes
are centered in shroud openings.
Secure ends of lower handle with two screws.
3.
Upper Handle (Fig. 4) – Handle height is
adjustable to three different heights for operator
comfort. Stand behind mower to gauge height.
Position ends of upper handle on outside of
lower handle. Select one set of upper handle
holes and align with lower handle holes. Secure
handles in place with bolts and knobs.
4.
If handles are in highest height position, use clip
to attach cable to left side of lower handle tube
(Fig. 5).
If handles are in lowest height position, use clip
to attach cable to right side of lower handle tube
(Fig. 6).
Install Side Discharge Chute
1.
Use handle on mulch door to raise door (Fig. 7).
2.
Hook side discharge chute onto pegs (Fig. 8).
3.
Lower mulch door on top of side discharge chute
(Fig. 10).
Before Starting
Charging Battery
It takes approximately 12–16 hours to charge a fully
discharged battery. Charge the battery after every
use. If the battery is not recharged after every use,
the battery life will be shortened. Recharge even if
mower is only run for a few minutes. This battery
does not have a "memory."
Note:
The battery is charged at the factory.
However, before using mower the first
time, it is necessary to recharge battery
and ensure it has a full charge before
operating.
To charge battery:
1.
Always charge mower in a dry area protected
from the weather. Also, keep mower away from
water and any flammable substances.
2.
If key is in plug receptacle, remove it (Fig. 11).
3.
Insert extension cord into the plug receptacle and
connect other end of extension cord to a normal
120 volt household outlet (Fig. 13). Refer to
Securing Extension Cord, page 7.
4.
The three vertical LED lights on the control
panel will indicate the charging status (Fig. 14).
Refer to the Charging Chart, page 7, for a
summary of the LED lights.
EN–6
Publicité
Chapitres
Table des Matières
