Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro 29730 Manuel De L'utilisateur

Figure 4
1. Handle knob (2)
Important: Route the cables to the outside of the
handle as you unfold the handle
1
2
3
Figure 5
Electric-start model shown
1. Cables
2. Wiring harness
(electric-start model only)
4. Install the handle knobs and tighten them firmly by
hand.
(Figure 5).
g025928
3. Handle
2
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 6).
1. Recoil-starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
1. Move the machine to a level surface.
2. Remove the dipstick
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 0.53 L (18 oz), type: 10W-30 or SAE
30 detergent oil with an API service classification of
SJ or higher.
5
Figure 6
2. Rope guide
(Figure 7) and pour about 3/4 of