Setup; Unfolding The Handle; Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro 29643 Manuel De L'utilisateur

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1

Unfolding the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the mower housing
(Figure 3).
Important: Route the cables to the outside of the
handle as you install the handle.
1. Handle knob (2)
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1 (Figure 3).
G020133
Figure 3
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 4).
1. Recoil-starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Important: The machine does not come with oil in
the engine.
1. Remove the dipstick (Figure 5).
5
Figure 4
2. Rope guide