Checking The Engine-Oil Level; Adjusting The Cutting Height - Toro 29730 Manuel De L'utilisateur

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Max. fill: 0.53 L (18 oz), type: 10W-30 or SAE 30 detergent
oil with an API service classification of SJ or higher.
1. Move the machine to a level surface.
2. Remove the dipstick
g032026
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube and screw it in
until it stops.
5. Remove the dipstick and read the oil level; refer to
Figure 12.
•
If the oil level is below the Add mark on the
dipstick, add a small amount of oil slowly to the
oil-fill tube, and then repeat steps
the oil level is at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick. To drain the excess
oil, refer to Changing the Engine Oil (page
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick securely by hand.
(Figure 12).
Figure 12
3 through

Adjusting the Cutting Height

Adjusting the Cutting Height
(High-wheel model only)
Adjust the cutting height as desired. Set the front wheels and
the rear wheels to the same height.
Note: To raise or lower the machine, move the cutting-height
levers as shown in
1. Raise the machine
Important: The cutting height settings are 32 mm
(1-1/4 inches); 44 mm (1-3/4 inches); 57 mm (2-1/4
inches); 70 mm (2-3/4 inches); 83 mm (3-1/4 inches);
and 95 mm (3-3/4 inches).
5 until
15).
9
Figure 13.
Figure 13
2. Lower the machine