Checking The Engine-Oil Level - Toro TimeMaster 76cm Manuel De L'opérateur

1. Clean around the fuel-tank cap and remove the
cap from the tank
Figure 12
1. Do not fill the fuel tank above the bottom of the fuel-tank
neck.
Important:
This machine is equipped with
a premium fuel tank that uses a foam insert
to prevent fuel agitation. Never remove the
foam element, because it allows the engine
to use all the fuel in the tank
Figure 13
1. Foam insert
2. Install the fuel-tank cap and tighten it securely
by hand.
(Figure 12).
(Figure 13).
Checking the Engine-Oil
Level
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
g197784
1. Full
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low
(Figure
g197639
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps
is at the correct level. For the oil type, refer
to Changing the Engine Oil (page
•
If the oil level on the dipstick is too high
(Figure
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page
Important:
low or too high and you run the engine, you
may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
10
Figure 14
3. Low
14), carefully pour a small amount
3 through 5 until the oil on the dipstick
14), drain the excess oil until the oil
If the oil level in the engine is too
(Figure 14).
g193261
(Figure 14).
19).
19).