Filling The Fuel Tank; Checking The Engine-Oil Level; Adjusting The Cutting Height - Toro 22in Recyler Mode D'emploi

Filling the Fuel Tank

DANGER
Gasoline is extremely flammable and explosive. A
fire or explosion from gasoline can burn you and
others.
• To prevent a static charge from igniting the
gasoline, place the container and/or machine
directly on the ground before filling, not in a
vehicle or on an object.
• Fill the tank outdoors when the engine is cold.
Wipe up spills.
• Do not handle gasoline when smoking or around
an open flame or sparks.
• Store gasoline in an approved fuel container, out
of the reach of children.
Fill the fuel tank with fresh unleaded regular gasoline from a
major name-brand service station
Use unleaded regular gasoline suitable for automotive use
(87 pump octane minimum). Leaded regular gasoline may be
used if unleaded regular is not available.
Note: Never use methanol, gasoline containing methanol, or
gasohol containing more than 10% ethanol because the fuel
system could be damaged. Do not mix oil with gasoline.
Important: To reduce starting problems, add fuel
stabilizer to the fuel all season, mixing it with gasoline
less than 30 days old.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
1. Remove the dipstick, wipe it clean, and insert it into the
oil filler neck, but do not screw it in
(Figure 7).
Figure 7
(Figure 8).
2. Remove the dipstick and check the oil level
If the oil level is below the Add mark on the dipstick,
slowly pour oil into the oil-fill tube to raise the oil level
to the Full mark on the dipstick. Do not overfill. (Max.
fill: 0.65 L (22 oz), type: 10W-30 or SAE 30 detergent
oil with an API service classification of SJ or higher.)
Note: If you overfill the engine, pour some oil out of
it as directed in Changing the Engine Oil (page
3. Install the dipstick securely.

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Shut off the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set the front wheels to
the same height as the rear wheels.
Note: To raise the machine, move all the cutting-height
levers rearward. To lower the machine, move all the
cutting-height levers forward
6
Figure 8
(Figure
(Figure 9).
8).
13).