Storage; General Information; Preparing The Fuel System - Toro TimeMaster 76cm Manuel De L'opérateur

1. Blade (2)
4. Tighten the second blade; refer to step 2.
5. Rotate the blades by hand a full 360° turn to
ensure that they do not touch.
Note:
If the blades touch each other, they are
not mounted correctly. Repeat steps
3, until the blades no longer touch each other.
WARNING
Incorrectly installing the blades could damage
the machine or cause an injury to you or
bystanders.
Use care when installing the blades.
Figure 47
1

Storage

Store the machine in a cool, clean, dry place.

General Information

1. Perform the recommended annual maintenance
procedures; refer to
2. Clean under the machine housing; refer to
g016536
Cleaning under the Machine (page
3. Remove chaff, dirt, and grime from the external
parts of the engine, the shrouding, and the top
of the machine.
4. Check the condition of the blades; refer to
Inspecting the Blades (page
5. Service the air filter; refer to
Filter (page
through
6. Tighten all nuts, bolts, and screws.
7. Touch up all rusted or chipped paint surfaces
with paint available from an Authorized Service
Dealer.
8. Electric-start model only: Charge the battery
for 24 hours, then unplug the battery charger
and store the machine in an unheated area. If
you must store the machine in a heated area,
you must charge the battery every 90 days.
9. Fold the handle for storage; refer to
the Handle Height (page

Preparing the Fuel System

WARNING
Fuel can vaporize if you store it over long
periods of time and explode if it comes into
contact with an open flame.
• Do not store fuel over long periods of time.
• Do not store the machine with fuel in the
fuel tank or the carburetor in an enclosure
with an open flame. (For example, a
furnace or a water heater pilot light.)
• Allow the engine to cool before storing it in
any enclosure.
On the last refueling of the year, add fuel stabilizer
to the fuel as directed by the engine manufacturer.
Empty the fuel tank when mowing the last time before
storing the machine.
1. Run the machine until the engine shuts off from
running out of fuel.
26
Maintenance (page
23).
Servicing the Air
19).
11).
18).
17).
Adjusting