Storage; Storage Safety; Cleaning And Storage - Toro TimeCutter ZS 4200S Manuel De L'utilisateur

Storage

Storage Safety

•
Shut off the engine, remove the key, and wait
for all moving parts to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel near flames or
drain the fuel indoors or inside an enclosed trailer.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.

Cleaning and Storage

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean
dirt and chaff from the outside of the engine
cylinder-head fins and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps, and
motors.
4. Check the parking brake operation; refer to
Position (page 10).
5. Service the air cleaner; refer to
Cleaner (page 30).
6. Grease the machine; refer to
30).
7. Change the crankcase oil; refer to
Engine Oil (page
8. Check the tire pressure; refer to
Tire Pressure (page
9. Charge the battery; refer to
(page 37).
10. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
machine with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
ARK
Servicing the Air
Lubrication (page
Servicing the
31).
Checking the
38).
Charging the Battery
11. Check the condition of the blades; refer to
Servicing the Cutting Blades (page
12. Prepare the machine for storage for over
30 days as follows:
A. Add fuel stabilizer/conditioner to fresh fuel
in the tank. Follow mixing instructions from
the fuel stabilizer manufacturer. Do not
use an alcohol-based stabilizer (ethanol or
methanol).
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank using a pump type
syphon or operate engine until it shuts off.
D. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
13. Remove and check the condition of the spark
plug(s); refer to
34). With the spark plug(s) removed from the
engine, pour 30 ml (2 tablespoons) of engine
oil into the spark plug hole. Use the starter to
crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install
the wire on the spark plug(s).
14. Check and tighten all fasteners. Repair or
replace any part that is damaged.
15. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
16. Store the machine in a clean, dry garage or
Park
storage area. Remove the key from the switch
and keep it out of reach of children or other
unauthorized users. Cover the machine to
protect it and keep it clean.
49
40).
Do not store fuel containing
Servicing the Spark Plug (page