Signature Kitchen Suite SKSDR360GS Manuel Du Propriétaire page 79

Problem
• Surface is not level 1. Range not leveled
• Oven is tipping 2. Anti-tip device not installed correctly
Approximately
0.65"
(16.5 mm)
• Flames too big on The installer missed part of the conversion.
converted cooktop (Check 2 parts: regulator, cooktop valve).
(NP  LP)
• Flame is too small or 1. Variable gas pressure
too large
2. Installer did not check
Cause
Anti-tip bracket
Screw must
Level both sides of range
enter wood or
concrete
Use carpenter's level to
check level.
2
1
regulator cooktop valve
Center adjustment screw
LIMITED WARRANTY
Prevention
• Check with installer first
Wall plate
• Check with installer first
• Refer to installation manual
• Check with installer first
79