Installing The Anti-Tip Device; Leveling The Range - Signature Kitchen Suite SKSDR360GS Manuel Du Propriétaire

22 INSTALLATION

Installing the Anti-tip Device

WARNING
Tip - Over Hazard
A child or adult can tip the range and
be killed. Verify the anti-tip bracket
has been installed. Ensure the anti-tip
bracket is engaged when the range
is moved. Do not operate the range
without the anti-tip bracket in place.
Failure to follow these instructions
can result in death or serious burns to
children and adults.
To check that leveling leg is
inserted into anti-tip bracket,
grasp the top rear edge
of the range and carefully
attempt to tilt it forward.
Anti-tip
bracket
Screw must
enter wood or
concrete
Locate the anti-tip bracket using the template.
An anti-tip bracket is packaged with the template.
The instructions include necessary information to
complete the installation. Read and follow the range
installation instruction sheet (template).
WARNING
• A child or adult can tip the range and be killed.
• Install the anti-tip device to the structure and/
or the range. Verify the anti-tip device has been
properly installed and engaged by following the
instructions on this template.
• Engage the range to the anti-tip device
following the instructions on this template.
Ensure the anti-tip device is reengaged when
the range is moved by following the instructions
on this template.
• Re-engage the anti-tip device if the range is
moved. Do not operate the range without the
anti-tip device in place and engaged.
• See installation instructions for details.
• Failure to do so can result in death or serious
burns to children or adults.

Leveling the Range

Front Legs
Level the range by adjusting the leveling legs with a
wrench. Extending the legs slightly may also make it
easier to insert the rear leg into the anti-tip bracket.
Rear Legs
Leveling
To adjust the rear leveling legs, remove the 2 screws
Anti-tip
leg
at the front of the vent trim and remove the trim.
bracket
Use an adjustable 7 mm box wrench to turn the rear
leg extension rods at each corner.
Wall plate
Use a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction
for level.
First check direction .
Then check direction . If the level doesn't show level
on the rack, adjust the leveling legs with a wrench.
Vent Trim
Rear Leg
Extension Rod
2
1