Signature Kitchen Suite SKSDR360GS Manuel Du Propriétaire page 23

Installing the Leg Cover
1
Remove the plastic covers from the stainless
steel leg covers.
2
Slide each small leg cover inside a larger leg
cover. Cutouts should face up and both covers
should be open at the back.
3
Use the assembled covers to conceal the front
leveling legs.
4
Place the outer covers on the floor and slide the
inner covers up until the holes at the top front
snap over the dimples on the flanges on the
bottom of the range.
Dimples
5
Insert the provided screws through the holes
in the leg cover assemblies to secure them in
place.
Installing Front Rail
1
Remove the plastic film from the stainless steel
front rail.
2
Insert the front rail onto the flange below the
oven door, aligning the holes in the top of the
front rail with the holes in the flange.
Front Rail
Flange
3
Use the 3 screws provided to secure the front
rail to the flange.
INSTALLATION 23