58 Maintenance; Control Panel; Gas Surface Burners - Signature Kitchen Suite SKSDR360GS Manuel Du Propriétaire

58 MAINTENANCE

MAINTENANCE
NOTE
• Depending on the model, your range may
contain different cooktop modules requiring
different maintenance procedures.
Take care when cleaning the range to apply
cleaners only as recommended.
CAUTION
• Do not clean this appliance with bleach.
• To prevent burns, wait until the cooktop has
cooled down before touching any of its parts.
• Always wear gloves when cleaning the cooktop.

Control Panel

Clean up splatters with a damp cloth using a glass
cleaner. Remove heavier soil with warm, soapy water.
Do not use abrasives of any kind.

Gas Surface Burners

Removing and Replacing the Gas
Surface Burners
Grates and burner heads/caps can be removed for
care and cleaning.
Burner cap is properly
set.
Burner cap is NOT
properly set.
Cleaning Burner Heads/Caps
For even and unhampered flame, the slits in the
burner heads must be kept clean at all times.The
burner heads and caps can be lifted off.
• Wash the burner caps in hot soapy water and rinse
• Use care when cleaning the cooktop. The pointed
• To remove burnt-on food, soak the burner heads
• The burners will not operate properly if the burner
• Burner caps and heads should be cleaned routinely,
• Burners will not light if the cap is removed.
General burner
After Cleaning the Burner Heads/
Caps
Shake out any excess water and then let them dry
thoroughly. Placing the burner heads upside down
will allow the water to drain out more easily. Replace
the burner heads and caps over the electrodes on
the cooktop in the correct locations according to
their size. Make sure the hole in the burner head is
positioned over the electrode.
with clean water. Run water through the burner
from the bottom stem to flush out debris.
metal ends on the electrodes could cause injury.
Hitting an electrode with a hard object may damage
it.
in a solution of mild liquid detergent and hot water
for 20–30 minutes. For stubborn stains, use a
toothbrush.
ports or electrodes are clogged or dirty.
especially after excessive spillover.
CAUTION
• Do not hit the electrodes with anything hard.
Doing so could damage them.
• Do not use steel wool or scouring powders to
clean the burners.
• Do not scratch or gouge the port features of the
brass burner bases.
• It is normal for brass burners to become
tarnished with use.
NOTE
• To clean the brass burners, use mild abrasive
cleaners or liquid cleaners.
• To clean port openings, use a stiff, nylon bristle
tooth brush.
• Do not use steel wool or steel bristle brushes
as they can scratch the brass burner surface.