Smart Diagnosis; Program Update; Demo Mode; Factory Data Reset - Signature Kitchen Suite SKSDR360GS Manuel Du Propriétaire

32 OPERATION

Smart Diagnosis™

Smart Diagnosis™ can be run through a smartphone
application or by calling for support. Place your
smartphone's mouthpiece near the top left corner of
the screen. See "Smart Diagnosis Function" in the
Smart Functions section for detailed instructions.
1
Touch Settings at the center bottom of the Main
screen, swipe to the third Settings screen, and
touch Smart Diagnosis.
2
Touch START to start the diagnostic tone.

Program Update

Once the appliance is connected to a home Wi-Fi
network, use this setting to check for available
programming updates and install them.
1
Touch Settings at the center bottom of the Main
screen, swipe to the third Settings screen, and
touch Program Update.
2
The display shows available programming
updates. Follow the onscreen prompts to
download and install the new version.

Demo Mode

Demo Mode for showroom use only. The oven will not
heat up.
1
Touch Settings at the center bottom of the Main
screen, then touch Demo Mode on the Settings
screen.
2
Select either the ON or OFF mode.
3
Touch OK.
NOTE
• When Demo Mode is on, the appliance will not
heat up.
• The oven Demo Mode icon appears in the
display if the Demo Mode is on.

Factory Data Reset

This function returns all settings to the factory
defaults.
1
Touch Settings at the center bottom of the Main
screen, swipe to the third Settings screen, and
touch Factory Data Reset.
2
If you want to reset data to the factory defaults,
touch RESET and then OK.
WARNING
• All stored data will be deleted.

Open Source License

This screen displays a list of the open source
software contained in this product. Refer to the
indicated licenses for the terms and conditions of their
use.
1
Touch Settings at the center bottom of the Main
screen and swipe to the fourth Settings screen.
2
Touch Open Source License.