Direct Input, Measuring And Function Modes; Twdrive Direct Inputs - Garant TWdrive Manuel D'utilisation

Description
No. Explanation
1 Set torque or
name of the sequence plan
DE
2 Set angle
(not in "torque" measuring mode)
3 Set function mode
peak (P)
track (T)
When vibration is switched on, "+V" is
displayed behind the function mode.
4 Currently present torque (in "angle-torque"
measuring mode, the currently present
EN
angle is displayed here)
5 Currently present angle
(not available in "torque" measuring mode)
(In "angle-torque" measuring mode, the
currently present torque is displayed here)
6 Malfunction/message symbol
(When processing a sequence plan, the
number of threaded connections already
completed and the total number of threaded
FR
connections to be carried out are displayed
here, e.g. 2/5)
7 Function-specific symbols (see following
table)
8 Battery status indicator (only visible on
switching on or if the battery status is
insufficient)
IT
12
ES
12
Symbol Explanation
Battery status indicator
Clockwise
Counter-clockwise
Angle measurement running
Taring process running
Taring process ended
Move upwards, increase values
Move downwards, reduce values
Administrator password required
No standard extension length set
An error has occurred
Direct input, measuring and function
modes

TWdrive direct inputs

Concrete values for a bolting operation are defined
in direct input.
The torque and angle wrench offers both torque and
angle mode.
The different measuring modes are used to define
the tightening process with which the bolting
operation is performed. After switching on, the
torque and angle wrench is always in one of the
four following measuring modes.
 Torque
 Angle
 Torque-angle
 Angle-torque
Description
Torque
In this measuring mode, a threaded connection is
only implemented according to the target torque.
The torque and angle wrench evaluates the
measured torque and responds with corresponding
signals:
 Signal lamps
 Audible signal
 Colour representation of the display value
 Vibration
For this to occur, you must have input the specified
values into the torque and angle wrench.
www.hoffmann-group.com
DE
DE
EN
FR
FR
IT
IT
ES
ES
13
13