Homologations; Fcc Information - Siemens SIMATIC Ident RFID RF300 Manuel Système

5.4.11

Homologations

FCC information

Siemens SIMATIC RF360R (MLFB 6GT2801-5BA30); FCC ID NXW-RF360R
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.
IC information
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d`Industrie Canada applicables aux appareils radio
exempts de licence. L`exploitation est autorisée aux deux conditions suivantes :
(1) L`appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l`appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d`en compromettre le fonctionnement.
UL information (IEC 61010-1 / IEC 61010-2-201)
This standard applies to equipment designed to be safe at least under the following conditions:
• a) indoor use;
• b) altitude up to 2 000 m;
• c) temperature -0 °C to 55 °C;
SIMATIC RF300
Manuel système, 02/2021, C79000-G8977-C345-09
Plots de lecture/écriture
5.4 SIMATIC RF360R
187