Daily Maintenance; Weekly Maintenance - EdilKamin IDROPELLBOX Installation, Usage Et Maintenance

MAINTENANCE
Before performing any maintenance, disconnect the appliance from the mains.
Remember to vacuum the combustion chamber before each ignition
Should ignition fail, do not re-ignite until you have emptied the combustion chamber
Attention: the pellet emptied from the combustion chamber mustnotbe deposited inside the hopper.
Regular maintenance is required for the boiler-fi replace to function correctly.
The boiler-fi replace will trigger the message: 'smoke °C/high' or 'Mainten.' to appear on the panel when further cleaning
is necessary. This is preceded by 'Clean exchang.' appearing on the display.
Failure to perform regular maintenance, at least on a seasonal basis, could lead to poor functionality.
Any problems resulting from lack of maintenance will immediately void the warranty.
NOTE: The DEALER, upon commissioning, sets the kg value of consumed pellets; after which, the message "SERVICE
UTE" will appear on the display. The boiler-fi replace continues operation, but the end client is invited to perform careful
maintenance, described above and explained by the DEALER during commissioning, to the extent of his abilities. To elimi-
nate the message from the display, press the boiler button for at least 5 seconds after having completed maintenance.

DAILY MAINTENANCE

Operations must be performed when the boiler- fi replace is off, cold and unplugged from the power supply
• Must be performed using a vacuum cleaner (see optional extras page 41), the whole procedure takes up a few minutes every day.
• Open the door, remove the combustion chamber (1 - fi g. A) and empty the residue out into the ash pan.
• Scrap the combustion chamber with the spatula provided, removing any obstructions in the openings.
• IN NESSUN CASO SCARICARE I RESIDUI NEL SERBATOIO DEL PELLET.
• Take out and empty the ash (2 - fi g B) pan into a fi reproof container (the ash may still contain hot parts and/or embers).
• Remove the combustion chamber or use the spatula to scrape it and clean out any blocked holes on all sides
• Vacuum the combustion chamber holder, clean the edges where the combustion chamber is lodged into its seat.
• Clean the glass, if necessary (when cold).
NEVER SUCTION HOT ASH, as this could damage the suction device and possibly cause a fi re.
1
2
fi g. A
fi g. B

WEEKLY MAINTENANCE

(picture on following page)
• Clean the hearth after having removed the ash pan (2 - fi g. C) and the smokebox plate (3 - fi g. C).
• Suction clean the smokebox compartment (4 - fi g. C)
• Clean the chimney fl ue using the swabs moving the relative metal levers up and down (6 - fi g. D).
• Clean the combustion chamber and the smoke extractor, paying careful attention (5 - fi g. C).
• To clean the chimney fl ue, proceed as follows:
Open the external door and the lower panel; remove the 3 screws to open the chimney fl ue's inspection hole and (7- fi g. E) and
suction the residue. The quantity of residue that forms depends on the type of fuel used and the type of system.
Note:
1) Be sure to close the inspection hole once this operation is complete.
2) Failure to clean the chimney fl ue will cause boiler-fi replace stoppage.
- 37
-