Electronic Equipment - EdilKamin IDROPELLBOX Installation, Usage Et Maintenance

ELECTRONIC CIRCUIT BOARD
SAFETY DEVICES
THERMOCOUPLE:
Placed at the smoke outlet to detect the temperature. Turns the
boiler-fi replace on and off and controls its operation based on
defi ned parameters.
VACUUM GAUGE (electronic pressure sensor):
Detects the negative pressure value (with respect to that of the
room of installation) in the combustion chamber.
WATER SAFETY THERMOSTAT:
Trips when the temperature inside the boiler-fi replace is too
high.
It stops pellet loading, causing the boiler-fi replace to go out.
Reset manually (see pag. 28).
TANK SAFETY THERMOSTAT:
Trips when the temperature inside the boiler-fi replac is too
high.
It stops pellet loading, causing the boiler-fi replace to go out.

ELECTRONIC EQUIPMENT

Panel control
RPM smoke
RS232
socket
RS 232
consolle
Boiler
circulator
(optional)
Smoke expulsion motor
Screw
Outlet pump
Optional
Water
boiler
outlet
Thermocouple T° smoke
probe
probe
Flow sensor
Vacuum gauge
RPM Screw 1
Vacuum gauge Reading points
Thermocouple
Screw 2
RPM
not to be used
battery CR 2032
Heat recovery
ventilation
FUSE 2A
TM RM 90°C
FUSE 2AT
TM 150°C
rear socket
RES ingnition
1
element
SERIAL PORT
The Dealer can install an optional on the AUX (located on
the electronic board), outlet for controlling the process of
switching on and off (e.g. telephone remote, local thermostat),
located at the rear oh the boiler-fi replace.
Can be connected via special optional trestle (code 640560).
BACKUP BATTERY
A backup battery is found on the control board (3-Volt CR
2032 battery).
Its malfunction is indicated with the following messages: (not
considered a defect but due to normal wear-and-tear): "Battery
check".
For more detailed information, please contact the DEALER
who has performed the fi rst 1st ignition.
- 25
-
230 Vac Power
50Hz +/- 10%