Possible Faults - ATIKA KSC 40-35 Notice Originale

Before each fault elimination:
 switch off device
 wait for the power pruner to come to a standstill
 remove the battery

After each fault clearance, put into operation and recheck all security installations.
Fault
Chain saw does not
start after switching on
Chain saw works with
interruptions
Chain saw picks,
vibrates or does not
saw correctly
Chain saw does not
work with full power
Saw chain gets hot
No saw chain
lubrication
Cutting time with fully
charged battery too
short
26
Possible cause
 Li-Ion battery run down
 Lithium-ion battery
correctly
 Li-Ion battery too cold/ too warm
 Li-Ion battery, Motor or switch defect
 external loose connection
 internal loose connection
 ON / OFF switch defective.
 Chain edgeless
 Chain worn
 Chain tension
 Chain not assembled correctly (teeth
face to wrong direction)
 The Li-Ion battery charge is low
 The Li-Ion battery is defect
 no oil in the tank
 oil flow canal blocked
 chain tension too high
 Chain edgeless
 no oil in the tank
 oil flow canal blocked
 Rechargeable battery is low
 Battery service life exhausted
 Chain soiled
 Chain blunt/worn
 Non chain lubrication

Possible faults

Remedy
 Charge the Li- ion battery
not inserted  Check whether the lithium battery has engaged audibly.
 Allow the lithium battery to warm up/cool down
 Have the battery, motor or switch checked / repaired by a
licensed electrician or customer service or replaced by
original spare parts.
 Contact the customer service
 Chain must be regrinded or exchanged
 Exchange chain
 Check and adjust chain tension
 Assemble chain again
 Charge the Li-Ion battery (manual battery "Charging the
battery"
 Contact the costumer service
 Refill oil
 Clean oil flow canal
 Adjust chain tension
 Chain must be regrinded or exchanged
 Refill oil
 Clean oil flow canal
 Charge the Li-Ion battery (Section "Charging the battery")
 Charging the rechargeable battery
 Clean the chain
 Chain must be reground or exchanged
 Replenish oil (Section "Chain lubrication")