Possible Faults; Technical Data - ATIKA KS 2002/40 Notice Originale

Possible faults

Before each maintenance and cleaning work
switch off device

 wait for stop of chain saw
 pull out main plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Chain saw does not
initiate after switching on
Chain saw works with
interruptions
Chain saw picks, vibrates
or does not saw correctly
Chain saw does not work
with full power
Saw chain gets hot
no saw chain lubrication

Technical data

Typ
Year of construction
Motor rating P
1
Mains voltage / Mains frequency
No-load speed n
0
Chain wheel (number of teeth/pitch)
max. guide bar length (length of sword)
Saw chain speed
Oil tank volume max.
Protection class
Sound power level L **
PA
measured sound power level L
guaranteed sound power level L
Uncertainty K / K
PA WA
Hand-Arm-Vibration
Uncertainty K
hd
Weight
Saw chain type
Pitch / drive link thickness
* (according to EN ISO 3744)
** (according to directive 2000/14/EC)
Possible cause
 Chain brake
 no power
 Extension cable damaged
 Main plug, motor or switch defect
 external loose connection
 internal loose connection
 Circuit closer/breaker defect
 Chain edgeless
 Chain worn
 Chain tension
 Chain not assembled correctly (teeth face to
wrong direction)
 Extension cable too long or diameter too small
 Power outlet to far away from main connection
 no oil in the tank
 oil flow canal blocked
 chain tension too high
 Chain edgeless
 no oil in the tank
 oil flow canal blocked
*
WA
**
WA
Removal
 Release chain brake
 Check power supply, power outlet, fuse
protection
 Check extension cable, exchange defect cable
immediately
 Have motor or switch checked by an approved
electrician or replaced by original spare parts.
 Check power supply, power outlet, fuse
protection
 Check extension cable, exchange defect cable
immediately
 Please contact the after sales service.
 Please contact the after sales service.
 Chain must be regrinded or exchanged
 Exchange chain
 Check and adjust chain tension
 Assemble chain again
 Use extension cable with sufficient diameter
 Use power outlet which is nearer within the
working area
 Refill oil
 Clean oil flow canal
 Adjust chain tension
 Chain must be regrinded or exchanged
 Refill oil
 Clean oil flow canal
9.525 mm (3/8") / 1.3 mm (.050")
KS 2002/40
see last page
2000 W
230 V~ / 50 Hz
8463 min
–1
7 x 9.525 mm (3/8")
400 mm
13.5 m/s
200 ml

92.55 dB (A)
103.55 dB (A)
109 dB (A)
2.5 dB (A)
a = 4.886 m/s²
hd
1.5 m/s²
ca. 5.7 kg
91 PJ 057X (Oregon)
29