Chain Wheel; Checking Of The Oil Automatic; Cleaning; Transport - ATIKA KS 2002/40 Notice Originale

Chain wheel

The demand of the chain wheel (13) is particularly great. Check
regularly the teeth of the chain wheel for wear or damages.
A worn or damaged chain wheel reduces the

durability of the saw chain and should therefore
immediately be exchanged by the customer service.

Checking of the oil automatic

Check the function of the automatic chain lubrication by
switching on the chain saw and holding it with the pike in
direction of a carton or paper on the ground.
Do not get in contact with the ground with the chain. Keep a
safe distance of 20 cm.
If an increasing oil track is caused when checking it the oil
automatic works faultless.
If there is no oil track despite full oil tank
clean the oil flow canal (14) and the upper chain
 
clamping boring (15).
 If this is not successful please contact the customer service.

Cleaning

Clean the chain saw thoroughly after each application so that
the faultless function is kept.
 Clean the case with a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
 Pay attention to that the ventilation slots for the motor
cooling are free (risk of overheating).
 In case of harder pollution or resins put the chain for some
hours in a container with chain cleaner. Afterwards wash up
the chain with clear water.
 Remove all adhering substances with a brush from the chain
wheel (13) and the guide bar fastening.
 Clean the oil flow canal (14) with a clean cloth.

Transport

Remove mains plug before each transport.
Transport the chain only with the chain protection put on.
When transporting the product within a car put it in the boot or
on a separate loading area. Secure the chain saw against
tipping over.
28

Storage

 Store unused equipment in a dry, locked place out of the
reach of children.
 To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
 thoroughly clean the chain saw
 Remove the oil from the oil tank.
Hint:
Some chain oils tend to encrustations after a longer
period. For this reason the oil system should be flushed
before a longer storing with a chain saw cleaner. Fill the
cleaner up to the middle (appr. 50 ml) into the oil tank.
Close the tank. Switch on the chain saw without
assembled guide bar and chain until the complete
cleaner has left the oil opening of the chain saw.
 Put the saw chain for a short time into an oil bath and
enwrap it afterwards in an oil paper.