Ec Declaration Of Conformity; Operating Times; Symbols Operating Manual; Symbols On The Chain Saw - ATIKA KSC 40-35 Notice Originale

EC Declaration of Conformity

No. (S-No.): 18431
according to EC directive: 2006/42/EC
We,
ATIKA GmbH
Josef-Drexler-Str. 8
89331 Burgau - Germany
herewith declare under our sole responsibility that the product
Kettensäge (Chain saw) type KSC 40-35
Serial number: 000001 020000
–
is conform with the above mentioned EC directives as well as
with the provisions of the guidelines below:
2014/30/EU, 2000/14/EC and 2011/65/EU.
Following harmonized standards have been applied:
EN 60745-1:2009+A11:10, EN 60745-2-13:2009+A1:10
EN 55014-1:2006+A1:2009+A2:2011, EN 55014-2:2015
Conformity assessment procedure: 2000/14/EC –
Appendix V
Measured sound power level L
Guaranteed sound power level L
Duly authorised person for the complilation of technical
documents:
ATIKA GmbH – Technical department – Josef-Drexler-Str. 8 -
89331 Burgau – Germany
Burgau, 28.06.2018
i. A. G. Koppenstein,
Engineering design management

Operating times

Before initiating the device please observe the provisions
pertaining to corresponding laws (regional provisions) for
the noise control.

Symbols operating manual

Threatened hazard or hazardous situation. Not
observing this instruction can lead to injuries or
cause damage to property.
 Important information on proper handling. Not
observing this instruction can lead to faults.
 User information. This information helps you to use
all the functions optimally.
Assembly, operation and servicing. Here you are
explained exactly what to do.
 Important notes for evironmentally compatible
conduct. Failure to observe these instructions may
lead to environmental damage.
Please refer to the attached assembly
and operating instruction sheet for
references to figure numbers in the text.
...
98.4 dB (A).
WA
99 dB (A).
WA

Symbols on the chain saw

Memorise the meaning to be able to operate the device more
safely and to protect yourself and other from possible injuries.
Carefully read operator
instructions before starting the machine and
observe the instructions when operating.
Wear hardhat, eye and ear protection.
Wear protective gloves.
Wear safety shoes.
Always hold the chain saw with both hands when
working with it.
Risk by kickback! Do not saw with the guide bar tip.
Do not expose to rain. Protect against humidity
Pull out the battery
 before starting any work (cleaning,
maintenance, repair, etc.) on the device.
 when interrupting work, during transport and
storage.
Economy mode – Normal mode
Chain brake disabled - OFF
Chain brake enabled - ON
Mind the running direction of the chain
links
Reduce the chain tension (-)
Increase the chain tension (+)
Max. cutting length 356 mm
Measured sound power level L
measured according to regulation 2000/14/EC)
This product complies with European regulations
specifically applicable to it.
Electrical devices do not go into the domestic
rubbish. Give devices, accessories and packaging
to an ecofriendly recycling.
According to the European Directive 2012/19/EU on electrical
and electronic scrap, electrical devices that are no longer
serviceable must be separately collected and brought to a
facility for an environmentally compatible recycling.
s manual and the safety
'
92 dB (A),
WA
17