Pneumatic Connection - Bosch TCE 4335 Notice Originale

en 30 | TCE 4335 | Initial commissioning
Warning - tilting danger!
The barycentre of the TCE 4335 does not lie
in its centre.
€
It is necessary to lift the machine slowly.
4. Lift the TCE 4335 with a lift crane and install it in the
designed area respecting the minimum distances s
shown in the picture.
i
For safe and ergonomic use of the TCE 4335 it is
recommended to leave a minimum of 500 mm space
from surrounding walls.
Warning - tilting danger!
During the functioning of TCE 4335 conside-
rable forces are exerted.
€
The TCE 4335 has to be fixed in at least 3
points on the floor (screw holes see chap.
4.2).
i
In each screw hole are placed shock absorbers to
reduce vibrations to the minimum.
5. Pre-arrange a suitable lubricator in the lubricator
holder bulb.
|
1 695 106 642 2010-12-22
4.3

Pneumatic connection

1. Connect the TCE 4335 to the compressed air supply
unit.
2. Adjust to a pressure between 8 and 12 bar.
« Pull the red knurled screw (pressure reducing val-
ve) fi rst upwards and then twist it to adjust ope-
rating pressure.
« Check pressure on the manometer.
Robert Bosch GmbH