Machine Positioning - Bosch TCE 4335 Notice Originale

4. Connect the supply pipes of the tank to the joint
located in the lower part of the tank (1).
5. Connect the air pipes to the rapid joints of the ma-
nometer, by inserting them in the appropriate holes:
the pipe coming from the front joint of the inflation
pedal (2) in the internal joint (nearer to the column),
the pipes coming from the rear joint of the inflation
pedal (3) in the external joint.
3
2
1
Robert Bosch GmbH
3
2
Initial commissioning | TCE 4335 | 29
4.2.7

Machine positioning

1. Put back in place the side door.
2. Loosen the two screws that fix TCE 4335 to the
pallet.
Warning - damage risk!
The lifting belts can crush the flexible supply
pipes of the cylinder or damage the applied
parts of the TCE 4335.
€
Insert the lifting belts carefully.
3. Insert the appropriate lifting belts (length belt 1: 1
Mt, belt 2: 3 Mt), with sufficient capacity, as shown.
2
!
en
1
|
1 695 106 642 2010-12-22