Leister GEOSTAR G5 Instructions D'utilisation page 66

Welding wedge position factory setting
The factory setting of the welding wedge was set to membranes with 2 mm thickness. Material thicknesses of
1 – 3 mm can be welded with this welding wedge position.
A. Press clamping lever locking device
(10) and swing clamping lever (7) up-
wards until the lock engages and use
your other hand to accomplish this by
holding the automatic welding machine
fi rmly by the handle (11) . Unlock wel-
ding force safety bolts (9) by pulling
and rotating 90°. Set the clamping arm
(4) to the maximum opening using the
welding force adjustment ring (8).
B. Prepare 2 mm test strips.
C. Vertical welding wedge setting:
Loosen slightly the two cylinder screws
(55) with socket wrench (wrench size 5
mm). Rotating the adjusting screw for
welding wedge, vertical (23) with the
socket wrench (wrench size 5 mm) ad-
justs the height of the welding wedge
(5). For the correct setting, the cylinder
screws (55) must be in the middle of
the slotted holes. Tighten the cylinder
screws (55) with 8.8 Nm.
66
11
200
500
7
10
9
8
4
23
55