Leister GEOSTAR G5 Instructions D'utilisation page 57

Display of day's distance
The welded distance is recorded as soon as the drive is running and more than 200 N force is displayed in the
working display (34).
The day's distance can be called up as follows:
Not in welding mode
• Using the arrow keys "Up" (27) and "Down" (28) to position the cursor on the speed in the working display
(34) .
• Holding down the "e-Drive"
• The values of the day's distance and the total distance are now shown in the speed display.
• Brief pressing on the "e-Drive"
In welding mode
• The Speed function display (34) is blocked during welding.
• The speed setting is enabled by briefl y pressing the "e-Drive"
• Holding down the "e-Drive"
• The values of the day's distance and the total distance are now shown in the speed display.
• Brief pressing on the "e-Drive"
Speed function display is blocked.
Speed blocked
for 5 seconds.
causes the speed to be shown again in the working display (34).
Hold pressed down for 5 sec.
Press briefly 1 ×
for 5 seconds.
causes the speed to be shown again in the working display (34) and the
Release speed
Display including day's distance
.
Display incl. day's distance
57